I just wanted to help add on this post to help any one out there , I used left over radiator hose from my 15 commander 1000 xt for the cut vent and heat tape rapped it . Have had 0 issues so far and have $45 in my snorkel kit including running the vent lines . Now there is trimming under the pod but that's it . Hope this helps
The air box inlet hose I cut about 5 inches back and uses a 1.5 inch street 90 to slide into the factor rubber inlet hose then 22 and 45 degree angles to go around the pod
The cvt intake I cut just under the bell for the screen and used a 2" -1.5" rubber cuppler and a 1.5" street 90 into the cuppler then 90 to 45 degree angles
Now the part you have to see to believe. And yes I heat shield rapped the hell out it lol
The cvt exhaust I used a 2" -1" rubber cuppler to go on the existing pipe in picture then a 1" 90 that had a fitting for the 1" inside diameter radiator hose from my wild bore rad relocate kit then run the hose where it's out if the way up beside the cut inlet there you will put in a 90 that s for the hose so it won't kink. Then a short about 8 inch piece of hose you run straight threw the plastic and beside the air box intake hose and out the other side to your fitting to go from the 1" hose to screw into a 1.5" adapter pic. Then a 1.5" 90 to a street 90 to a 45.
I'msorry in advance for my pour directions look at the pictures please. This is on my 14 outlander 800r xt . You will need a 10ft stick of 1.5 " off pipe . I used about 7 ft of it