4. CVT EXHAUST cont.
The first pic in this post shows where i angled back forward and slightly to the inside with a 45 into a 22.5 and then run back into a 1.5" to 2" and then 2" turned back to the right with a 90 and short piece of pipe and then another 45 straight into a short 90 turned straight up through the plastics. The second pic again shows where i came up through the plastics on the right side, the belt intake and exhaust snorkles side by side. The third pic shows what it looked like from the top side when i was done. You can see when i first did my bike i used 2" to 2" rubber couplers where i came through on the top side and just run up my pipe with 2 90's on top. Also i put dielectric grease in every electrical connection i could find and extended the vent lines for the gas tank, rear differential, and coolant overflow bottle
2005 custon blue/yellow Kingquad 700
29.5" OL2's on STI HD2 alloys
2" HL lift
HMF utility pipe
VDI ecu and M109r injector
custom center snorkles
Last edited by king05; 10-19-2010 at 11:35 AM.