Mud in My Blood Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi all, been using this site for info for ages, finally made an account as I'm looking for some jetting info that just isn't quite covered elsewhere that I could find. Mods/machine as follows:

06 Prairie 700
HMF full exhaust
K&N air filter
Dynatek CDI
Moose Power Module

Had a shop take care of jetting when they rebuilt the top end, currently runs like an absolute champ. Will be doing 2" snorkels, intake crossover, and polished slides all at once and can't seem to nail down what if any jetting changes it will need. Crossover should call for bigger jets and nearly the same back to front but I'm thinking the snorkel may counter-balance the crossover a bit?

Just looking for a little advice on where to even start.

Motor is stock, all relevant mods as listed
 
1 - 1 of 1 Posts
Top