[khalil0900]

Ok, When I put my 2005 brute force 750 into gear everything works as it should. But once I give it gas it revs up before anything engages like the clutch is just sitting there then engages all at once. I have no clue why its doing this it just progressively has gotten worse and I dont know how to fix it. Has anyone ever had this problem??????

 

[NMKawierider]

When was the last time the clutches were serviced and the belt's deflection checked? Probably overdue..

 

[khalil0900]

It's got a newer belt on it and I put new clutch springs on it and it still does it

 

[NMKawierider]

It's got a newer belt on it and I put new clutch springs on it and it still does it

Ok, what exactly is the deflection set at and what springs did you put in it. Are the flyweights free and no pin is binding?

 

[2010Bruterider]

Take the primary off. Remove the spring. Lay it down on a table and see if the sheaves close all the way together.
I had my clutch slip on the crank once, causing it to over tighten itself. It bulged the inner sheave and ruined it. My clutch would only fall half way closed.


Sent from my iPhone using Tapatalk

 

[FABMAN]

you need to take both clutch off clean and inspect the. you should remove both clutch springs. On the primary remove fly weights clean and inspect, inspect the spider buttons that slide on the movable sheave. Also disassemble the helix on the secondary clean and inspect. and check your belt deflection.