Mud in My Blood Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Just bought a 2002 prairie 650. Display not working. Just wonderi g if there is a way to bench test it and see if it works or if it is a wiring problem.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #2 ·
Ok I just found out how. The four wire plug with clip facing up on left is hot on right is ground. Also run hot to left bottom wire. This should make display come on.

---------- Post added at 08:25 PM ---------- Previous post was at 08:24 PM ----------

Clip facing up and contects facing you.
 

·
Registered
Joined
·
452 Posts
In manual it gives the entire run down to test each part of it and what pin does what
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top