Mud in My Blood Forum banner

Spongy brake pedal

1216 Views 1 Reply 2 Participants Last post by  Polaris425
My truck is a custom build and he ran the brake lines higher than the master cylinder. Once it gets air in there, it is a bear to get it out of the high spots. I'm thinking of putting a three way splitter at the high point with a cap on it and bleeding breaks from there. Any suggestions on other ways to bleed them?
1 - 2 of 2 Posts
Can't just re-route them?
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.