Joined Feb 7, 2012
·
15 Posts
Ok another question:
After engine shout off ( by key) , how many second does it buzz the engine brake actuator?? i count till 7. is it ok?
Joined Apr 11, 2009
·
8,560 Posts
Ok another question:
After engine shout off ( by key) , how many second does it buzz the engine brake actuator?? i count till 7. is it ok?
Yeah...that's about normal.
Joined Feb 7, 2012
·
15 Posts
Yeah...that's about normal.
Thank You! Sometimes it`s 11 sec.....
Joined Nov 10, 2011
·
93 Posts
The video on how to take apart and clean the actuator isnt showing up. Know where i can find the video that will work? My 4x4 actuator has a little vibration coming from it.
Joined Dec 16, 2004
·
22,078 Posts
video works for me... it's hosted on vemeo... could that site be blocked where you are? did you try just refreshing the page?
Joined Nov 10, 2011
·
93 Posts
The second video on how to test the actuator shows up and i can play it. The first one wont load up or anything it just says sorry and error has occured
Joined Dec 16, 2004
·
22,078 Posts
second video is on youtube... must be vemeo for you then.
Joined Nov 10, 2011
·
93 Posts
So maybe try from a different computer or ??
Joined Dec 16, 2004
·
10,379 Posts
ill see if i can get it on youtube. i think they raised the time limit i can upload a vid.
before it was capped and i was unable due to the size.
Joined Nov 10, 2011
·
93 Posts
Joined Nov 10, 2011
·
93 Posts
I found it on Viemo! Thanks again!
Joined Aug 12, 2011
·
10 Posts
for the 4wd actuator how do i get the little arm that goes inside the diff off so i can take the shaft out to clean it?
Joined Jun 13, 2011
·
232 Posts
^^^There is a small pen that knocks out of the square block.
Joined Aug 12, 2011
·
10 Posts
thanks man, couldn't see it because of the worn surface, got it though, i appreciate it!
Joined Aug 12, 2010
·
186 Posts
Does the engine brake actuator output shaft need to go inside ring that slides up and down on the part the output shaft goes in or not?
Joined Apr 11, 2009
·
8,560 Posts
Does the engine brake actuator output shaft need to go inside ring that slides up and down on the part the output shaft goes in or not?
If you are talking about where the output shaft drops through and into that sloted section at the fork, Yes...
Joined Aug 12, 2010
·
186 Posts
Joined Aug 10, 2011
·
414 Posts
Can you Exchange the KEBC actuator with the 4x4 actuator?
Joined Nov 18, 2011
·
160 Posts
I think the output shafts are different
Joined Aug 10, 2011
·
414 Posts
You have to Change Shafts and Base. Switch is Wired Backwards and the Motor Runs backwards.
I just Figured it out and got it to Work.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.