I wouldn't think you'd need spacers.

 

I think you will be fine. As far as I know the offset is the same front and rear, but stock rims are different widths. So if you mean the same width wheel as well, then you should still be ok b/c they will have the same offset. The stock ones will have a slightly different offset b/c they are not the same width, so to track the same, one has to have more offset.

 

Yes same wheel all four corners. The msa diesels only come in one size for 4/137 bolt pattern. 7 wide with 4+3 offset. I need to know what width this will put me at front and rear? Will it be the same? Do I need spacers? I actually want to go a little wider.

 

I dont think you will NEED spacers, and they should stick out alittle farther than stock... so unless you just want them... I'd still see what they look like first though, then order spacers based on if its wide enough for you.

 

So it will be same width front and rear? I know the wheels are different offsets and widths but don't know if putting same wheel and offset will make it different widths front and rear.

 

No it shouldnt b/c the distance between the hubs F&R should be the same... The reason the stock rims are different offset's is b/c they are different widths, so for them be the same track width on the outside, one of them (the thinner one) has to have more offset so it tracks the same....

Putting the same width same offset rims all around should make them equal F&R.

UNLESS I'm wrong, and the track width to the outside of the hub is different, but I dont think it is.

If you want ot be %100 sure just take a tape measure to the hubs F&R and see.

 

Yeah I'm on a pipeline job about 6 hours away and can't put a tape on it. I was trying to order parts so they were there when I got home.

 

I can measure mine this afternoon when I get home to be %100 positive, if you can wait that long.

 

Sure thanks.

 

Just got this reply in a txt from a Teryx friend:

"if u take everything off and measure width of outside hub to outside they the same"